Hi Sergei,
I found many replies from you in the forum which helped me a lot.
Especially those discussion about the 3D simulation.
Here, I attached a file where I want to simulate the plane wave propagation with arbitrary incident angle.
However, I want to use periodic port because in later time, I want to use it to simulation some periodic structures.
But to my surprise, the simulation do not converge. There must be sth wrong with it.
Do you have any experience on this?
Hope you can help if possible.
Many thanks!
I found many replies from you in the forum which helped me a lot.
Especially those discussion about the 3D simulation.
Here, I attached a file where I want to simulate the plane wave propagation with arbitrary incident angle.
However, I want to use periodic port because in later time, I want to use it to simulation some periodic structures.
But to my surprise, the simulation do not converge. There must be sth wrong with it.
Do you have any experience on this?
Hope you can help if possible.
Many thanks!